Crown-pro Crown Moulding Cutting Guide

Features

Description

The product is a 10/100TX - 100BASE-FX WDM Bi-directional Fiber Converter - 1510NM - 20KM LFPT. It supports both half-duplex and full-duplex operations and a variety of fiber options. The converter auto-adapts to the highest level of performance supported by the device connected to the STP port. When the device is a switch or a workstation that supports full duplex, the converter adapts to the full-duplex mode and provides an effective 200Mbps bandwidth.

When the connected device is a hub or a workstation that supports only half duplex, the converter adapts to the half-duplex mode and provides the nominal 100Mbps bandwidth. An override switch provides total manual control over the half/full-duplex operation in fiber-optic interface. The fiber port of the converter operates at 1310 nm and uses ST, SC, MTRJ, VF45 or WDM connectors.

Multi-mode models that support distances up to 2km and single-mode models that support distances up to 15/20/35/50/60km are available.

Crown-Pro

Take the guesswork out of cutting crown molding Installing crown molding is one of the best ways to add instant value to your home.

The Kreg Crown-Pro simplifies the most frustrating steps of the process, so you make fewer mistakes and get the job done faster! Exact Angles This uniquely-designed tool holds your trim at the exact angle required, eliminating the need for advanced compound miter cuts and difficult 'coping.' Versatile & Compatible Its curved design lets you compensate for a wide variety of crown molding spring angles, and its extension arms lets you work with crown up to 5 1/2' (140mm) wide. Easy Angle Finder The Crown-Pro comes with an adjustable Angle Finder that easily shows you the exact angle of inside and outside corners.

Plus, you can use the Angle Finder to check the spring angle of your crown molding. 10' (254mm) saws will work with crown up to 3 1/2' (89mm) wide, depending on manufacturer. 12' (305mm) saws will work with crown up to 5 1/2' (140mm) wide, depending on manufacturer.