Solar Charge Regulator 12V 10A

The Nemtek Solar Charge Regulator 12V 10A 140W is designed to efficiently convert the output from a solar panel to a level suitable for charging a 12V lead-acid battery, while Mean Power Point (MPP) technology ensures that the maximum available power is harvested from the solar panel. The regulator provides an output to drive a 12V load with a current consumption of up to 10A, as well as a load disconnect function to protect the system and battery against under-voltage and over-current.

Five LEDs indicate the charging state, battery condition and load state. This LED solar regulator offers advanced MPP technology for over 90% efficiency when used with a 140Watt solar panel. It can also be used with solar panels sizes from 20Watt to 200Watts making it very flexible. Product Code: SOL-REG140 FEATURES OF THE NEMTEK SOLAR CHARGE REGULATOR 12V 10A: LED display indicates and shows solar charge, battery condition and load indication, Set to operate as a 12VDC system, The regulator is equipped with various devices to protect its electronics, Ideally suited for electric fencing that requires solar panels and batteries in remote areas.

SPECIFICATIONS OF THE NEMTEK SOLAR CHARGE REGULATOR 12V 10A: Power Handling Capability 140W Efficiency @ 140W >90% Maximum Solar Panel Input Voltage 24VDC Solar Panel Input Range 20W 200W Battery Charge Voltage 14.3VDC Suitable Lead Acid Battery Types Flooded, AGM, Gel Recommended Battery Capacity (Solar Panel < 90W) >40Ah Recommended Battery Capacity (Solar Panel > 90W) >90Ah Maximum Flat Battery (11 VDC) Charge Current 11A (Over Current Protected) Maximum Load Supply Current 10A (Over Current Protected) Load Disconnect Voltage ~11.2VDC Quiescent Current 60mA Operating Temperature -20 55C Terminal Size 6mm2 / 12AWG Mounting Hole Size 5mm Product Dimensions 200mm x 120mm x 37mm Product Weight 290g Packaging Dimensions 240mm x 160mm x 160mm Mass of unit packed 450g Warranty 12 months limited Manufacturers warranty WARNINGS AND LIMITATIONS OF THE NEMTEK SOLAR CHARGE REGULATOR 12V 10A This system may pose a fire hazard if not properly installed, Always take care not to create a short circuit between opposite polarities, This solar regulator employs positive switching.

Never connect the positive outputs to a common point, It is highly recommended to install a 20A fuse in line with the positive polarity cable from the regulator to the battery, Do not attempt to charge any battery other than a 12V lead-acid battery with a capacity that is matched to the solar panel and load, Always ensure sufficient ventilation for the regulator and battery.

The regulator should always be mounted on a vertical surface to ensure proper heat dissipation of the metal back plate, Ensure all terminal screws are tightened firmly, Keep the unit away from excessive moisture. WHATS IN THE BOX: 1 x Nemtek Solar Charge Regulator 12V 10A Limitations:The images shown are for illustrative purposes only.

Actual product may vary slightly.