Description
The product is a water filling sprayer. It is suitable for use with 0.4MM airbrush. The voltage is 100v-240v, the adapter is 5v 1.0a, the max pressure is 20psi, the air flow is 7L/MIN, and the working time is 50Min. The charging time is 1.5 hours, and the airbrush will interrupt operation on charging time. The USB LED display is on: red light, full charged: blue light.
InformationProduct Name:Water Filling Sprayer
Voltage:100v-240v
Adapter:5V 1.0A
Max Pressure:20Psi
Air Flow:7L/MIN
Suitable For:0.4MM Airbrush
Worwing Time:50Min
Charging time is 1.5 Hours,It Will Interrupt Operation on Charging Time
USB LED Display:ON:Red Light,Full Charged:Blue Light on
Including1*Micro Air Pump
1*Airbrush
1*USB
Key tips1. The product used in the airbrush must be a water-based product (high-density products must be diluted with mineral water)
2. Spray warm water or alcohol before spraying (cleaning the inner wall of the airbrush)
3. After each use, it is necessary to inject warm water to clean the side, and spray the air conditioner for a few seconds (to avoid the nozzle being clogged or leaking due to the product drying)
4. Do not leave the product in the bottle for a long time, how much to put it (to avoid the nozzle being clogged or leaking due to the product drying out)
5. Receive the instrument fully charged before use, display red when charging, full of green.
6. Do not use while charging, then pick up the power and then pick up the use
Why the airbrush does not spray waterFirst, the nozzle is not screwed into place
Second, the black "small rubber seal" on the nozzle is gone.
Third, the "tight nut" at the rear of the airbrush is not tightened.
Fourth, the product concentration is too high (preferably diluted to water)
Fifth, there are dirty things in the airbrush that have not been cleaned in time.