Engraving Machine 3 Axle Cnc Engraving Machine Control Board With Control Panel 12V 5V For Woodworking Diy

Manufacturer

Unbranded

This is a control board for a 3-axle engraving machine. It has a control panel and supports low light and power regulation. It is suitable for DIY woodworking engraving machines, laser engraving machines, writing robots, and 3-axle engraving machines.

Features:
Applicable to 2-phase 4-wire stepper motor (2A), laser module in 10W (12V, 5V), support 48V 400W spindle (using on-board relay).Integrated master chip + 3 stepper motor driver + MOS switch circuit, can be used for DIY laser engraving machine, drawer machine, CNC engraving machine. and many more.Integrated three A4988 drivers for direct connection to four-wire stepper motors.Support laser or spindle,2-pin or 3-pin port laser (pwm laser),;12V, 5V TTL and no TTL laser , Y-axle dual motor,xyz limit switch, probe interface.Adjustable drive subdivision and A4988 can be replaced with 8825 driver. DIY woodworking engraving machine, laser engraving machine, writing robot, 3-axle engraving machine control board, support secondary development, open data, suitable for computer,switch application.The board supports low light and power regulation. USB connection. 12V power supply, with related software and tutorials. Laptop, desktop computers are available.

Specification:
Voltage: 12V
Current: 5A
Suitable for Application:Miniature butler, miniature quick map, GrblController, Grbl Control, CNC USB, CNCC, etc.


Package List:
1 x USB Cord
4 x 4P Terminal Cord
2 x 2P Terminal Cord
1 x 3P Terminal Cord
1 x Control Panel
1 x Control Panel Wire
1 x 3 Axle Control Panel

Users Manual:
The display has only one knob and the knob can be rotated and pressed left and right.
Rotate: Change the menu item to be selected, change the value, change the engraving speed, and so on.
Press: menu to confirm the selection.