Description
This product is a water filling sprayer that is compatible with airbrushes that have a 0.4mm nozzle. The product has a voltage of 100v-240v and a max pressure of 20psi. The air flow is 7L/MIN and the working time is 50 minutes. The product can be charged in 1.5 hours and will interrupt operation when it is charged. The product has a USB LED display that shows the status of the battery, which is red when it is charging and blue when it is full.
Information Product Name:Water Filling Sprayer
Voltage:100v-240v
Adapter:5V 1.0A
Max Pressure:20Psi
Air Flow:7L/MIN
Suitable For:0.4MM Airbrush
Worwing Time:50Min
Charging time is 1.5 Hours,It Will Interrupt Operation on Charging Time
USB LED Display:ON:Red Light,Full Charged:Blue Light on
Including 1*Micro Air Pump
1*Airbrush
1*USB
Key tips 1. The product used in the airbrush must be a water-based product (high-density products must be diluted with mineral water)
2. Spray warm water or alcohol before spraying (cleaning the inner wall of the airbrush)
3. After each use, it is necessary to inject warm water to clean the side, and spray the air conditioner for a few seconds (to avoid the nozzle being clogged or leaking due to the product drying)
4. Do not leave the product in the bottle for a long time, how much to put it (to avoid the nozzle being clogged or leaking due to the product drying out)
5. Receive the instrument fully charged before use, display red when charging, full of green.
6. Do not use while charging, then pick up the power and then pick up the use
Why the airbrush does not spray water First, the nozzle is not screwed into place
Second, the black "small rubber seal" on the nozzle is gone.
Third, the "tight nut" at the rear of the airbrush is not tightened.
Fourth, the product concentration is too high (preferably diluted to water)
Fifth, there are dirty things in the airbrush that have not been cleaned in time.