Jadpes Skateboard Electric Skateboard Longboard Dual Drive Skateboard Controller Esc Substitute Control Mainboard With Remote

Brand	Unbranded
Manufacturer	Unbranded

This product is a skateboard controller that has a remote control transmitter that matches the main controller. The controller has a double drive with a voltage of 36V and a current of 12A. The controller can reach a maximum RPM of 3000 and a maximum power of 430W. The controller has a drive mode that is a sine wave and the FOC has a slow start. The controller has a maximum speed of 35KM/H. The controller has protection features such as over-voltage, under-voltage, over-temperature, stall, CWCCW, and speed control. The controller has a sensing method of Hall. The controller has a carrying weight of 120KG and a power connector of XT60. The motor plug is of 4mm banana plug. The Hall interface is of 5pin 2.0 connector. The size of the controller is approx. 18.5*10*4cm / 7.28*3.94*1.57in and the weight is approx. 227g.

Specifications:
Double drive: 100*76*18mm
Voltage: 36V
Current: 12A
Maximum RPM: 3000 rpm
Maximum power: 430W (36V)
Drive mode: sine wave FOC has a slow start
Maximum speed: 35KM/H
Protection: over-voltage, under-voltage, over-temperature, stall, CWCCW, speed control
Sensing method: Hall
Carrying weight: =120KG
Power connector: XT60
Motor plug: 4mm banana plug
Hall interface: 5pin 2.0 connector
Size: approx. 18.5*10*4cm / 7.28*3.94*1.57in
Weight: approx. 227g
Package List:
1 * Control
1 * Remote Control Transmitter
1 * LED Battery Indicator
1 * Switch
1 * USB cable
The remote controller matches the main controller with a signal description:
1: Connect the main control to the power supply
2: The power is turned on, wait for two seconds, then press and hold the key for about 6 seconds. Wait until the switch indicator flashes.
3: Turn on the remote control switch and use a small screwdriver to press the button inside the small hole in the lower left corner of the remote control.
4: The remote control is turned off for two seconds and then turned on. Wait for the remote control signal light and the switch signal light to flash at the sametime to indicate that the match is successful.