Description
The Poly Strapping Tensioner & Cutter is a manual tool used for banding with polyester or polypropylene straps that are 3/8 inch to 3/4 inch in width. It is compatible with these strap sizes and has dimensions of 11'' x 6'' x 3''. To use the tool, the handle is squeezed to lift the gripping jaw and the strap is threaded through the back of the tool. The strap is then wrapped around the load and the handle is swung to tension it. A seal is placed on both straps and a sealer is used to crimp them. Finally, the handle is squeezed to cut the strap.
Specifications:
The tensioner and cutter is used with 3/8 inch to 3/4 inch poly strapping.
Compatible With: 3/8-3/4-inch poly strapping
Dimensions (L x W x H): 11'' x 6'' x 3''
HOW TO STRAPPING
1. Squeeze the handle to lift the gripping jaw
2. Thread the free end of the strap through the back of the tool under the gripping jaw, leaving approximately 1? of overhang front of the tool.
3. Wrap the strap around the load
4. Take the end of the strap still attaching to the coil and thread it through the cutter housing and the shaft slot
5. Swing the handle to tension the strap
6. Place seal on both straps and using the sealer to crimp
7. Squeeze the handle to cut the strap
Related Products
