Description
This is a product for use in 3D printers. It is a resin that can be used to create objects using a UV light. It is made of monomer and photo initiator, and has an exposure time of 25-60 seconds, with each layer taking 3-15 seconds. It has a viscosity of 150-200 Mpa.s, and an absorption wavelength of 355-410nm. The product has a liquid density of 1.05-1.25g/cm, a solid density of 1.05-1.13g/cm, a tensile strength of 36-62MPa, an elongation of 11-20% and a bending strength of 50-70MPa. The product has a thermal deformation temperature of 120? and a volume shrinkage of 3.72-4.24%. The product has a Shaw hardness of 84D.
Specifications: Main Material: monomer and photo initiator
Exposure Time: Bottom layer 25-60s, each layer 3-15s recommended
Viscosity: 150-200 Mpa.s (NDJ-8S Rotary viscometer 25?)
Absorption Wavelength: 355nm-410nm
Liquid Density: 1.05-1.25g/ cm
Solid Density: 1.05-1.13g/ cm
Tensile Strength: 36-62MPa
Elongation: 11-20%
Bending Strength: 50-70MPa
Thermal deformation temperature: 120?
Volume shrinkage: 3.72-4.24%
Shaw hardness: 84D
Storage Method: Please put the product in a dry and ventilated room without corrosive gas, avoid direct sunlight. (Sunshine contains a lot of UV light, will solidify photosensitive resin. After testing, the light is not affected as long as it is not UV light).
It is recommended to save at 15 ? -35 ? ambient temperature, the lower the temperature, the higher the viscosity of the resin. Sealed storage, excessive dust or moisture can affect print quality.
Matters Need Attention: 1. This product is single-used and cannot be reused.
2. This material can't touch eyes, skin or clothes, and shall not be drunk. Use only in a well-ventilated environment, please pay attention to air circulation and take protective measures. Clean thoroughly after operation.
3. The product is liquid state with slight smell. Please wear a mask when using, so as to avoid inhalation of aerosol and infection.
4. The product should be stored in a sealed container. The product should be sealed in time and placed in a dry and well-ventilated place after using.
5. In case of accidental inhalation or swallowing, do not induce vomiting, and promptly send to the hospital for treatment.
6. In case of accidental contact with skin, wash skin with soap and water or seek medical advice.
7. In case of accidental contact with eyes, open the eyelid immediately, rinse with soapy water and seek medical advice immediately.
Related Products
