Dish Network 20.1 Ir Satellite Receiver TV1 Replacement Remote Control

Brand	Unbranded
Manufacturer	Unbranded

The Dish Network 20.1 Ir Satellite Receiver TV1 Replacement Remote Control has a "no RF section" and cannot be setup in SAT mode, so if the remote control cannot work, the user must press and hold the TV device button until the device lights up, enter the code 1005, and the device flashes twice, indicating that the setup is finished. Additionally, the remote may need to be programmed. To test whether this is necessary, the user must press the POWER button on the receiver to turn it on, and follow this up by turning on their HDTV or other television. Once the programming guide pops up, the user can press the GUIDE button on their remote, and if the programming guide doesn't show up, they can press the SYSTEM INFO button on their receiver once. Once the user enters the three-digit code, the mode button they're programming will light up. The user then presses the POUND (#) button once, which should cause the specific mode button to blink three times. The user's device should now be configured.

The remote has no RF section and cannot be setup in SAT mode. So, If you have tried and the remote control can't work, press and hold the TV device button until the device lights up, enter the code 1005, and the device flashes twice, this indicates that the setup is finished. ADDITIONALLY: Although your remote may already be configured to work with your DISH receiver, there's a chance that you may need to program it. To test whether this is necessary, press the POWER button on the receiver to turn it on, and follow this up by turning on your HDTV or other television. Press the GUIDE button on your remote, and if the programming guide pops up, you can skip to "Programming 20.1 IR Remote for Other Devices." If the guide doesn't show up, press the SYSTEM INFO button that's located on your DISH receiver once. This will bring up the System Info screen. On your remote, press the SAT button, which should illuminate the SAT light. Press the RECORD button once. This will again cause the SAT button to light up. After entering the three-digit code, the mode button you're programming will light up. Press the POUND (#) button once. This should cause the specific mode button to blink three times. Your device should now be configured. Test this by pressing the VOLUME, PLAY, or other buttons related to the device.