Description
This product is a skateboard controller that includes a remote control transmitter and LED battery indicator. It is designed to be used with a double drive skateboard that has a 100*76*18mm size, 36V voltage, 12A current, and 3000 rpm maximum RPM. The controller has a sine wave drive mode and can reach a maximum speed of 35KM/H. It also has protection features such as over-voltage, under-voltage, over-temperature, stall, and CWCCW. The sensing method is Hall and the carrying weight is 120KG. The power connector is XT60 and the motor plug is 4mm banana plug.
Specifications: Double drive: 100*76*18mm
Voltage: 36V
Current: 12A
Maximum RPM: 3000 rpm
Maximum power: 430W (36V)
Drive mode: sine w-ave FOC has a slow start
Maximum speed: 35KM/H
Protection: over-voltage, under-voltage, over-temperature, stall, CWCCW, speed control
Sensing method: Hall
Carrying weight: =120KG
Power connector: XT60
Motor plug: 4mm banana plug
Hall interface: 5pin 2.0 connector
Size: approx. 18.5*10*4cm / 7.28*3.94*1.57in
Weight: approx. 227g
Package List: 1 * Control
1 * Remote Control Transmitter
1 * LED Battery Indicator
1 * Switch
1 * USB cable
NOTE: No Installation Guides are included, professional usage is strongly recommended.
The remote controller matches the main controller with a signal description: 1: Connect the main control to the power supply
2: The power is turned on, wait for two seconds, then press and hold the key for about 6 seconds. Wait until the switch indicator flashes.
3: Turn on the remote control switch and use a small screwdriver to press the button inside the small hole in the lower left corner of the remote control.
4: The remote control is turned off for two seconds and then turned on. Wait for the remote control signal light and the switch signal light to flash at the sametime to indicate that the match is successful.
Related Products
