Description
This is a set of 3 endstop switches designed for use with a RepRap Mendel 3D printer. Each switch comes with a 70cm cable and features a thick 22AWG copper wire that can handle up to 2A of current and 300V of voltage. The switches also have a wide temperature range and are easy to plug in and use. The board size is approximately 39 x 16 x 7mm and the cable length is 70cm. The connection instructions are to connect the red wire to VCC, the black wire to GND, and the green wire to SIGNAL. It is recommended to have at least three of these switches configured in the system. The package includes 3 endstop switches.
3Pcs RAMPS 1.4 Endstop Switch For RepRap Mendel 3D Printer With 70cm Cable
Features:
It using 22AWG wire, copper wire inside is very thick, can be resistant to current 2A, 300V voltage. An insulating layer over a wide range of temperatures, up to 80 degrees. Is the common connection of thin copper wire can not match. Not easy to pull off, plug it convenient, for ease of use, plug the other side to do the one, you can use the direct plug
Board Size: Approx. 39 x 16 x 7mm / 1.54 x 0.63 x 0.28 inch
Cable Length: Approx. 70 cm / 27.56 inch
Connection Description:
Red line connecting VCC (ramps of +)
Connect the black wire GND (ramps of -)
Green Line connection SIGNAL (ramps in s)
Tips: Under normal circumstances, the system must be configured to at least three mechanical switches.
Package Included:
3 x 3D Printer Endstop Switch
Related Products
