Jfosiyo Stud Finder Wall Scanner Digital Stud Sensor Electronic Ac Live Wires Finder Metal Detector Pipe Detector Behind Wall Floor Ceiling Comfortable Grip Ergonomically Design

Manufacturer

Unbranded

The JFOSIYO wall scanner detector is a professional tool that can be used to locate studs in walls and ceilings. The tool has a green LED that lights up when it is calibrated and ready for scanning. The scanner can be moved horizontally across the wall to locate studs. Once the studs are located, the red LEDs will light up and the tool will beep to indicate that it has found the stud. The center of the stud can then be located by moving the scanner back to the middle of the two marks that were made while scanning the wall.

JFOSIYO has a professional team to be dedicated to design and produce multi-function stud finders. We can provide you 24 month warranty and superior after-sales service. Please feel free to contact us if you have any questions!

How to use JFOSIYO wall scanner detector?
(1)Power on
Press the switch button and hold it to switch on the tool.
Release the switch button will turn off the tool.
It is suggested to place the tool against the detecting surface before switch on the tool. Because when the tool is switched on, it will proceeds a self-calibration procedure and get ready for operation.

(2)Calibration
When the unit is powered on, it will do the calibration procedure as follows: Press the switch button and hold it, the green LED lights up. Hold the unit in still position flat against the testing surface until a beep sounds that indicates a good calibration. This process takes about several seconds.
After calibration the green LED remains lighting up.

(3) Scanning
After calibration has finished, slowly slide the unit across wall in a horizontal direction. Make sure not to tilt or lift the tool.
When the lower red LED starts to light up, slow down and slide the tool further until top red LED lights up and the tool beeps.
Mark this spot to indicate stud edge. Continue scanning beyond the marked spot until all the red LEDs go out.
Then slide the unit in reverse direction to locate the other edge of stud in the same manner.
Mark this second spot. Center of stud is the middle between the two marks.