Description
Zooltro Sliding Gate Motor | 800 Kg CapacityZooltro Sliding Gate Motor | 800 Kg CapacityProduct details:Brand: ZooltroProduct: Sliding Gate Opener MotorMotor voltage: 24V DC Gear drivenOutput power: 200 wattsOutput torque: 18NmMaximum gate weight: 800 KGLimit switch: MagneticWorking duty: S2, 30 minutesGate move speed: 11-13 m/minAdditional remote controls that can be connected: Max 25Receiver frequency: 433.92MHzNoise: 56dB;Working temperature: -15 to +60 degrees CelsiusOverheat protectionWorm gear is brassWorm is #45 steelSoft start & slow stopObstruction detection with automatic reverse;Interface for Solar panel, strobe light, infrared sensor, GSM Gate Opener Remote Relay SwitchMaterial: Aluminium base. Waterproof caseSupports 24V(2x12V) backup battery for use when electricity goes out. 4.5Ah or 8Ah recommendedBackup battery not includedSupport wireless keypad: YesAdjustable Auto-close function, and time delayPedestrian mode.Lockable Manual key release design for emergency manual operation.Easy to install and set upEasy Interface Feature, No complicated controls or buttons with this unit.Multiple Modes of Operation.Adaptive Collision Sensing.Ideal for high volume traffic like a residential complex or delivery entrance at malls. Power the motor through electricity and solar or one of the two methods:Connect a 40w solar panel to the motor eliminating the needs for electricity connections, the solar panel will in turn charge the battery and the motor will draw power directly from the batteryConnect 230v electric power from your electricity connectionInstallation tips:Be sure the gate is properly installed and slides smoothly before installing the sliding gate operator.The gate must be plumb, level, and move freely.In order to protect the cable, use PVC conduit for low voltage power cable and control wires.Conduit must be pre-set into the concrete when it is poured. Wires within the conduit shall be located or protected so that no damage can result from contact with any rough or sharp part.The base unit of the gate operator requires a concrete pad in order to maintain proper stability.The concrete pad should be approximately 24 (600mm) x 12 (300mm) x 18 (460mm) deep in order to provide for adequate operation.Once the gate is mounted adequately, electrical power is available, and the concrete pad is poured, you are ready to proceed.Package includes: 1 Gate motor1 control board (Inside motor)2 Remote controlMagnetic limit switch & accessories2 Manual release keyBolts & nuts
Related Products
