Description
This product is a flight controller for drones. It has an MCU, IMU, baro, and OSD. It also has a blackbox, but no VCP and 2x UARTs. It has 2x motors, 5x servos outputs, 1x I2C, 3x LEDs for FC STATUS (Blue, Red), and a 3.3V indicator (Red). The FC firmware is NAV. The PDB has input voltage range of 6.5~30V (2~6S LiPo), 2x ESC power pads, and a 3.3V ADC. The BEC 5V output is designed for the flight controller, receiver, OSD, camera, and buzzer. The BEC Vx output is designed for the servos. The 3.3V output is designed for the baro / compass module/ OLED and Spektrum RX. The FC has a linear regulator and can output 200mA. The physical dimensions are 24x24mm, F2mmDimensions: 41x28x10mm, and the weight is 7g.
FC MCU: 100MHz STM32F411
IMU: MPU6000 accelerometer/gyro (SPI)
Baro: BMP280 (I2C)
OSD: INAV OSD w/ AT7456E chip
Blackbox: No ,VCP andamp; 2x UARTs
2x Motors, 5x Servos outputs ,1x I2C
3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red)
Built in inverter for SBUS input (UART1-RX)
SoftSerial_Tx1: ST1 pad by default
PPM: ST1 pad with softserial disabled
Battery Voltage Sensor: 1:10 (Scale 1100)
WS2812 Led Strip : Yes ,Beeper : Yes , RSSI: No
FC Firmware NAV Flight
Target: MATEKF411
PDB Input voltage range: 6.5~30V (2~6S LiPo) w/TVS protection
2x ESC power pads,Current Senor: 78A, 3.3V ADC, Scale 423
BEC 5V output Designed for Flight controller, Receiver, OSD, Camera, Buzzer, 2812 LED_Strip, Buzzer, GPS module, AirSpeed
Continuous current: 2 Amps
BEC Vx output Designed for Servos
Voltage adjustable, 5V Default, 6V via jumper
Continuous current: 3 Amps
BEC 3.3V output Designed for Baro / Compass module/ OLED and Spektrum RX
Linear Regulator,Continuous current: 200mA
Physical Mounting: 24 x 24mm, F2mmDimensions: 41 x 28 x 10mm
Weight: 7g (Total 12g w/ bottom plate and M2 standoffs)
Package Including1 * Matek F411-WING Flight Controller Built-in OSD
Related Products
