Description
The document provides instructions for installing a gear indicator on a motorcycle, specifically for Yamaha XJ6 ABS 2009-2015, XT250 2005-2019, and XT1200Z Super Tenere 2010-2013 models. The indicator requires 4 wires to be connected to the bike's wiring harness, and no cutting or soldering is necessary. The connections can be made under the fuel tank, at the ECU box, or behind the instrument cluster. The document includes a table with an overview of the connections and recommends consulting with a dealer or referring to the service manual for specific wire colors and installation instructions. The installation process involves locating the speed sensor coupler, which is typically located on the gearbox or at the front or rear wheel. The document also includes a fitment section listing the compatible bike models.
Instructions Guide:
You need to connect 4 wires to the bike?s wiring harness. Good quality quick connectors are supplied (4 pcs wire taps). No need to cut any wires and no need for soldering.
All connections can be done either under the fuel tank, at the ECU box or behind the instrument cluster.
The table below shows the connection overview:
GFYSHIP wire
Red Connect to +12V switched power lead
Black Connect to Ground lead or chassis ground
White Speed Signal, tap anywhere between the Speed Sensor and instrument cluster.
On some ABS models, tap the speed signal anywhere between the ABS computer and ECU box.
Green Connect to Tacho signal, tap anywhere between the ECU box and instrument cluster.
Alternatively, tap the signal wire from the 2-wire
Crankshaft Sensor (Pickup coil), anywhere between the sensor and ECU box.
To complete the install, it is recommended that you consult with your dealer and/or refer to the Service Manual available for your bike.
Due to the large number of bike models and vehicles compatible with this Kit, model specific wire colors and install instructions are not described in this document.
1. The ignition key should be in OFF position. Remove the seat, raise and support the fuel tank
2. Locate the Speed Sensor coupler.
A. Most motorcycles have the speed sensor mounted on the gearbox. Others have the sensor mounted either at the front or at the rear wheel.
B. Trace the cable until you find the speed sensor coupler. It is a 3-pole connector (except BMW, which use 2-pole).
C. If in doubt, check the bike?s Service Manual or ask your dealer for the location of the Speed Sensor coupler.
Fitment: For Yamaha XJ6 ABS 2009-2015
For Yamaha XT250 2005-2019
For Yamaha XT1200Z Super Tenere 2010-2013
Related Products
