Eston 2 Pack 88 Printhead Replacement For 88 Print Head C9381A C9382A For Office Jet Pro K5400 K5400DTN K5400DN K5400TN

Manufacturer	Unbranded
Model Number	B01E8LZH40

The printer has printheads that need to be replaced. The steps to replace the printheads are as follows:

1.Press the power button to turn on the printer.
2.Open the top cover.
3.Press and hold the resume button until the carriage moves to the left.
4.Lift the printhead latch.
5.Lift the handle of a printhead and use it to pull the printhead out of its slot.
6.Shake the new printhead at least six times while the printhead is still in its packaging.
7.Remove the new printhead from its package, and then remove its orange protective caps.
8.Insert the printhead into its color-coded slot (the label on the printhead must match the label on the printhead latch). Press down firmly on the printhead until it snaps into place.
9.Pull the printhead latch all the way forward, and then press down until the latch engages.
10.Close the cover.
11.The printer should align the printheads automatically in a few minutes, printing an alignment page. If it does not, go to the next section to align manually.

If your printer do not recognize the

Replacing printheads

Follow these steps to replace the printheads in your printer.
1.Press thePowerbutton to turn on the printer.
2.Open the top cover.
3.Press and hold theResumebutton until the carriage moves to the left.
CAUTION:

Be careful not to proceed until the carriage is on the left side of the printer.
If the carriage does not move to the left automatically, turn the printer off and back on and then try holding down theResume button again.
The printhead can be damaged if the carriage is not all the way to the left for installation.

4.Lift the printhead latch.
5.Lift the handle of a printhead and use it to pull the printhead out of its slot.
6.Shake the new printhead at least six times while the printhead is still in its packaging.
7.Remove the new printhead from its package, and then remove its orange protective caps.
8.Insert the printhead into its color-coded slot (the label on the printhead must match the label on the printhead latch). Press down firmly on the printhead until it snaps into place.
9.Pull the printhead latch all the way forward, and then press down until the latch engages.
10.Close the cover.
11.The printer should align the printheads automatically in a few minutes, printing an alignment page. If it does not, go to the next section to align manually.
NOTE

Please click "OK" if the printer shows errror message
If your printer do not recognize the ink cartridge at the first time, please take it off and install again.
If still can not, please remove the affected cartridge and turn off the printer for 30 min, clean the chip softly with alcohol or eraser, then turn on the printer and install the cartridge again.